Before sharpening a chainsaw, operators must secure the power source by removing the spark plug wire, battery, or electrical plug, SlashGear reported.
A simple Oregon Universal Chainsaw Field Kit contains correctly sized round files for the cutting teeth, a flat file for rakers, a file handle, and a file guide.
The guide serves as both a tool to maintain proper angles on the cutting teeth and a measuring instrument for the rakers, which function as the cutting tooth depth gauge. Raker height establishes the exact depth at which the following cutting tooth bites into wood.
Manufacturers typically recommend a raker height of 0.025-inch below the edge of the following cutting tooth. Cutting teeth slope toward the rear, meaning a new chain sits slightly higher than one that has undergone multiple sharpenings. Lowering the cutting tooth height without filing the corresponding raker results in the saw removing less wood with each pass.
If an operator files a raker too low, it increases the depth of cut for the related tooth. Filing too many rakers below the recommended threshold creates saw and chain problems, safety hazards, and increased operator fatigue.
An improperly maintained saw chain remains a primary factor behind chainsaw kickback. Kickback occurs when the guide bar and spinning chain violently rotate backward toward the operator.
Setting raker height requires simple tools once the sharpening process is mastered. Operators can use an Oregon chainsaw chain depth gauge and a flat file.
Placing the depth gauge directly on the saw chain allows the raker to protrude through a slot. Filing the raker with the gauge in place wears the gauge down over time, so users can alternatively check the raker height with the gauge, remove it to file a stroke or two, and recheck.
Another measurement method involves laying a straight edge across the tips of the cutting teeth and using a 0.025-inch feeler gauge from Harbor Freight to check the gap. If the feeler gauge fails to fit into the gap, users must file a couple of strokes from the raker tip and check the height again.
Periodic sampling of remaining rakers ensures consistent height across the entire chain.