Nine days. That is how long a dry, rubbery patch imaged a volunteer’s blood flow without drying out — roughly 100 times longer than the hydrogel layer MIT’s Zhao Lab fielded in 2022.
Engineers at MIT and the Singapore-MIT Alliance for Research and Technology (SMART) have built a solid elastomer that replaces the cold gel every ultrasound scan still requires, publishing the results in Science. The material, an interpenetrating network of “bottlebrush” polymers, transmits sound waves as efficiently as water-based gel but wicks sweat and survives stretching — two failure points that have kept wearable ultrasound stuck in the lab.
Bottlebrush architecture cuts acoustic friction
Ultrasound waves travel easily through fluids because small, loosely bound molecules slide past each other with minimal energy loss. In conventional rubbery solids, long polymer chains tangle into a dense thicket; the wave dissipates as those chains grind against one another.
The MIT team, led by postdoc Shu Wang, sidestepped the tangle by synthesizing polymers with a bottlebrush topology — a central backbone bristling with short side chains that “don’t easily penetrate other bottlebrush molecules,” Wang said. “They can easily move around at the ultrasound frequencies, and that’s why there is less friction between them.”
First batches crumbled like tofu. “If the samples were too large, they would not hold their own weight, and if you picked one up, it would just break,” Wang said. The fix was a second, loosely cross-linked bottlebrush network fused into the first — an interpenetrating elastomer that retains the low-friction acoustics while gaining skin-like toughness.

From phantom to treadmill to a Charlestown bike ride
Credit-card-sized samples on a synthetic phantom — a stand-in for human tissue — delivered clear images continuously for nine days. “In principle, this material could go forever, depending on how stable it is,” Wang said. “The sound properties stay the same.”
On a volunteer’s chest during a 10-minute treadmill run, conventional silicone rubber became waterlogged with sweat; the bottlebrush patch wicked moisture away and maintained adhesion.
The decisive field test: a key-fob-sized patch on a cyclist’s neck, tethered to a tablet, imaging carotid blood flow for 30 minutes over steep inclines from MIT’s Cambridge campus to Bunker Hill in Charlestown and back.

Why gel fails on wearables
Clinical ultrasound relies on a technician replenishing gel when it dries. Wearables have no technician. Zhao Lab’s 2022 hydrogel patch lasted 48 hours before desiccation killed the acoustic coupling. “In a doctor’s office, a technician can simply apply more gel if needed,” mechanical engineering professor Xuanhe Zhao said. “But for a wearable device, gel-based designs can limit their long-term usability.” The dry elastomer removes that ceiling entirely.
Fabrication scaling is the next bottleneck
The SMART WITEC (Wearable Imaging for Transforming Elderly Care) consortium, backed by Singapore’s National Research Foundation and MIT’s Health and Life Sciences Collaborative, is now streamlining synthesis. Co-lead author Runze Li framed the target: “If we want ultrasound imaging that goes beyond the clinical scenario, we need a material that lasts longer, and is easier to handle. And we think this really works.”
“We are really aiming to address a material challenge in ultrasound imaging. If you don’t have a good interface, that will definitely stop you from developing this wearable imaging field.”
Founded in 1861 by geologist William Barton Rogers to accelerate American industrialization, MIT moved from Boston to its Cambridge campus along the Charles River in 1916.
The institute became the nation’s largest non-industrial R&D contractor during World War II through projects such as the Radiation Laboratory, and later helped shape federal support for basic science. Today it operates off-campus facilities including Lincoln Laboratory and the Broad and Whitehead Institutes, and counts 107 Nobel laureates among its affiliates as of October 2026.
The paper, “Interpenetrating Bottle-Brush Elastomer for Low-Loss Soft Ultrasonic Interfaces,” appears in Science.