“These stacks of Mylar can bend, withstand substantial compression and maintain their insulating performance,” Igor Bargatin, Associate Professor in Mechanical Engineering and Applied Mechanics at the University of Pennsylvania, told Science Daily.
Establishing a permanent human presence on the Moon requires protecting astronauts and equipment from extreme temperatures ranging from hundreds of degrees below zero to boiling hot. While reliable insulation is essential, materials must also survive transportation, installation, accidental impacts, and years of handling in the vacuum of space.
Researchers at the University of Pennsylvania developed a material known as hybrid layered insulating film stacks, or HyLIFS. The team arranged many extremely thin Mylar sheets into carefully designed stacks to combine thermal insulation and resistance to physical damage.
Mylar is a well-known plastic formally called biaxially oriented polyethylene terephthalate, or BoPET. The polymer is widely used in aerospace technology and reflective emergency blankets distributed after marathons.
Adding a metallic coating such as aluminum allows Mylar to reflect infrared radiation. To increase sheet stiffness, the team tested varying film widths and deposited ultra-thin layers of aluminum oxide—also known as alumina—onto select samples.
“At the moment, the process is very time-consuming,” Danielle R. Levin, a recent Penn doctoral graduate in chemistry who also received a master’s in MEAM, told Science Daily. “We use two pairs of tweezers and small weights to handle and stack the delicate films. Even breathing near the stack can send the layers flying.”
When placed in a vacuum, the top-performing stacks maintained flexibility while reaching thermal conductivity levels matching other cutting-edge vacuum insulation products. The researchers subjected the material to repeated compression to test durability under conditions similar to a lunar habitat.
The samples underwent compression reaching roughly 20 megapascals, equivalent to exerting 200 pounds of pressure on a fingertip-sized space. The team repeated the process 10 times in a row.
“We were concerned about the material failing under such high compressive stress,” Levin told Science Daily. “But the stacks didn’t survive just one high stress cycle — they survived 10 in a row.”
The experiments uncovered how heat travels through layers of Mylar via microscopic antiblocking particles already present in commercially manufactured plastic films. These tiny particles prevent extremely thin sheets from sticking to one another during manufacturing.
Mathematical models and laboratory measurements indicated that much of the heat moving from one Mylar sheet to the next passes through the tiny contact points created by these particles. In thinner sheets, the particles produced more contact between adjacent layers, creating additional routes for heat to move through the material.
“As you compress the layers, the contact landscape changes,” Levin told Science Daily. “It’s not just a matter of minimizing the film thickness or the number of particles; we must also account for how the contacts change and the films deform as pressure increases.”
Experimental HyLIFS samples currently measure only about one square centimeter, and producing them requires manual stacking. Researchers will need a more efficient production method, such as continuously applying coatings to large rolls of Mylar.
The research was published in ACS Applied Materials & Interfaces.
“The combination of thermal and mechanical robustness is critical for long-term use on the Moon,” Levin told Science Daily. “This material could open a pathway to inexpensive, durable and reusable lunar insulation.”