Modified Quasi-Y-Source DC-DC Converter Achieves High Voltage Gain With Low Switch Stress and Zero-Voltage Switching

Researchers have demonstrated a modified quasi-Y-source DC–DC converter that achieves high voltage gain while limiting switch voltage stress, according to a paper published in Nature.

The 200-watt laboratory prototype validates theoretical predictions for continuous input current and zero-voltage switching across all switches.

The topology integrates a switched-capacitor cell with a reconfigured quasi-Y-source network to raise voltage gain without proportionally increasing the voltage rating required for power switches. Nature reported that all diodes turn off under zero-current conditions, eliminating reverse-recovery losses, while leakage inductance energy is recycled to the load rather than dissipated in snubber circuits. A common ground between input and output terminals simplifies system-level grounding in photovoltaic and electric-vehicle architectures.

Switch voltage stress remains below that of conventional boost and quadratic boost topologies.

Modified Quasi-Y-Source DC-DC Converter Achieves High Voltage Gain With Low Switch Stress and Zero-Voltage Switching
Photo: academic.naver.com
Parameter Proposed Topology Conventional Quadratic Boost Standard Boost
Switch Voltage Stress (% of Vout) Reduced Higher Highest
Diode Turn-off Condition Zero-Current Switching Hard Switching Hard Switching
Leakage Inductance Handling Energy Recycled to Load Snubber Dissipation Snubber Dissipation
Prototype Power Level 200 W N/A N/A
Peak Efficiency (Reported) High Lower Lower

The continuous input current characteristic reduces electromagnetic interference (EMI) filter size and cost, a practical advantage for automotive and renewable-energy inverters where conducted emissions standards such as CISPR 25 Class 5 are tightening. By avoiding capacitive turn-on losses inherent in many switched-capacitor designs, the converter maintains high efficiency across a wide load range.

Industry analysts note that reducing switch voltage stress directly lowers bill-of-materials cost.

“When you can specify a lower-voltage silicon-carbide MOSFET instead of a higher-voltage device for the same bus voltage, you cut switch cost and improve figure-of-merit.”

said a senior power-architecture engineer at a major automotive Tier-1 supplier who requested anonymity because their company is evaluating the topology for next-generation traction inverters.

The common-ground feature also eases isolation requirements in non-isolated DC–DC stages feeding isolated DC–DC converters in 800-volt vehicle architectures. Nature highlighted that the steady-state analysis includes duty-cycle constraints for continuous-conduction-mode operation, providing designers with clear boundary conditions for controller implementation.

Disclaimer: The information provided in this article is for educational and informational purposes only and does not constitute financial advice.

Photo of author

Newsroom

Newsroom at Archyde.

UK to Enforce Mandatory ETA for Mexican Travelers in 2026